Dbx-pro 260 Manuel d'utilisateur télécharger pdf (Page 12)

Getting Started

DriveRack™ User Manual

Section 1

DriveRack

™

Output Meters

The DriveRack 260 provides the user with six independent six-segment Lightpipe™ output

meters that range from -30 to +22 dBu.

For those of you that wish to jump right in, the following information has been provided to

act as a quick start guide for optimizing performance of the DriveRack 260.

Signal Path Block Diagram

The following diagram shows the logical and intuitive signal path of the input, effect mod-

ules, and output of the DriveRack 260.

Connections

• When setting up the DriveRack 260, make connections as follows:

•Always

make connections prior to applying power to the unit.

• Connect the output from the sending device (mixer) to either of the two XLR

inputs connectors shown below.

• Make output connections from any one of the six output XLR connectors shown

below to the input of the selected power amps.

• Connect the selected RTA microphone to the RTA XLR input.

• I

MPORTANT- It is recommended that the power amps are turned off prior to cycling power to the Driverack

260. Always make sure that your power amps are the last item turned on and the first turned off.

Once all of the connections have been made and the unit is powered up, you can

navigate through the entire signal path of the DriveRack 260 from the front panel of

the unit. The display provides you with a clear and concise overview of each aspect

260 Signal Path

WIRE

RTA

MIXER

ROUTING

A+B

RTA

1.3 Quick Start

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 82 83

Pas de commentaire

Dbx-pro 260 Manuel d'utilisateur Page 12